Working with braided PVC

I'm in the process of doing my overflow pluming. I bought 1.25" braided pvc and this stuff isn't very flexible at all! lol

Heres some pictures of my problem


it curves around the back just fine. Might get a zip tie to hold it around the middle of the stand there

but when it enters my sump, its way too high


id like to find a way to have it sit lower somewhere like


any ideas from people who have dealt with this before, or maybe there is an obvious solution i'm just missing

thanks!

 

get a barbed slip X barbed slip 90deg piece

the store that sells that barbed piece going to your bulkhead will most likely sell this piece, its the same type

 

Actually, I wish I went with this over PVC because it is easier to work around corners while still getting the most out of your pump.

You could try zip-tying it to the tank? I forget what most people use for that problem. lol.

 

What he said.

 

sounds easy enough, i knew there was a simple solution i just wasn't thinking of thanks a lot

 

success

 

Congrats. I'll be following your build.

 

thanks! I probably should have posted this question on my build page lol.. its here

http://www.3reef.com/forums/new-hobby/my-first-75g-build-posting-pictures-advice-welcome-121825.html