Micromussa Fragging 101

Discussion in 'Frags' started by mikejrice, Jan 7, 2016.

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

  1. mikejrice

    mikejrice 3reef Affiliate

    Joined:
    May 24, 2009
    Messages:
    5,761
    Location:
    Colorado


    Methodology:

    The method I use for fragging the majority of hard corals is primarily the same with the cutting tooling being a Gryphon band saw.

    Cooling liquid used is fresh mixed saltwater with enough iodine to color it a light amber. This helps to disinfect cuts as they're made which has shown to greatly increase frag survival.

    All corals are stored during cutting in a small bucket holding water taken directly from their home aquarium. This water is used both to keep them wet as well as for rinsing any flesh away from cuts while I'm working on them.

    All finished, and rinsed, frags or trimmed colonies are soaked in Brightwell Aquatics Restor dip to insure that minimal flesh is lost.

    Both soak buckets are rinsed and replenished between colonies to reduce the risk of interactions between loose flesh of different coral species.

    Notes about micromussa:

    Micromussa are one of the corals that will bear significant advantages if corallite boundaries are followed, so when cutting these corals, I always try to follow directly along the top of corallite walls.

    As with most LPS corals, cutting frags as thinly as possible will help to accelerate growth.

    Micromussa build one of the most dense skeletons I've come across, so they can be quite hard to cut. Be sure to take your time and let the blade do the work.