kalk in ato

So wat if u do it in ato u have to clean the switch ?

 

I'd just buy a doser.... figure out your evap and then program your doser to accomplish that rate....

 

And what i meant by that is you don't have to dose it all at once, you can spread it out during the entire day instead of topping off at a certain level( the best time is when then lights are off to stabilize the PH.

 

I run a kalk stirrer with an osmolator, I have it setup up through my apex so it turns on the Tunze 1 minute every hour for safety.

 

Frank. Forum shorthand now and then is ok but this is a bit much here and throughout this thread. I am not sure what you are asking. The answer may depend on which ATO you are talking about too.