Here's one for the blooper reel, but it does bring up an exytra tip to anyone using a bandsaw. When turning during cuts, be sure to keep the saw speed up and turn as you cut! Twisting a blade inside a cut is a quick way to end a fragging session. Methodology: The method I use for fragging the majority of hard corals is primarily the same with the cutting tooling being an Inland band saw. Cooling liquid used is fresh mixed saltwater with enough iodine to color it a light amber. This helps to disinfect cuts as they're made which has shown to greatly increase frag survival. All corals are stored during cutting in a small bucket holding water taken directly from their home aquarium. This water is used both to keep them wet as well as for rinsing any flesh away from cuts while I'm working on them. All finished, and rinsed, frags or trimmed colonies are soaked in Brightwell Aquatics Restor dip to insure that minimal flesh is lost. Both soak buckets are rinsed and replenished between colonies to reduce the risk of interactions between loose flesh of different coral species. Notes about acans: Acans are one of the corals that will bear significant advantages if corallite boundaries are followed, so when cutting these corals, I always try to follow directly along the top of corallite walls. As with most LPS corals, cutting frags as thinly as possible will help to accelerate growth. Acans build one of the most dense skeletons I've come across, so they can be quite hard to cut. Be sure to take your time and let the blade do the work. Cuts sped up 4x. Blade break slowed down .50x If there's a specific species you would like to see fragged, please comment below.