Mawnkey's 40 Breeder build.

What is a flare nozzle?

Sent from my EVO 3D using Tapatalk

 

It gives a wider flow on the output of your return line (from sump).

flare nozzle | Marine Depot

Choose 2.5" flare nozzle if your return line will be 1/2". Choose 3" flare if return will be 3/4" plumbing.

 

Alright I think that kit looks good

Sent from my EVO 3D using Tapatalk

 

Okay so I will check to see if my local lfs has any kits

Sent from my EVO 3D using Tapatalk

 

Started cutting all my pieces for my stand. Plus I'm helping my cousin with his 20L stand as well

Sent from my EVO 3D using Tapatalk

 

First part of stand complete

Sent from my EVO 3D using Tapatalk

 

Sent from my EVO 3D using Tapatalk

 

Looks good! Are you planning on using any strong ties to help support the corners?

I used these myself:

Simpson Strong-Tie GA2 3 1/4" x 1 1/4" Gusset Angle

Simpson Strong-Tie Wood to Wood Angle

 

Actualy yes. I stopped at the bottom and top of the stand. I decided that I had made it to tall. And it is to late to make cuts. I still am worried about the legs being stable. I just plan on using the braces to hold them together while the glue dries. Is this acceptable?

Sent from my EVO 3D using Tapatalk

 

I used glue and screws myself. The screws will hold it together just fine. How tall are your legs? I put a shelf towards the top of my stand to help with stability. Are you planning on putting the legs in between the top and bottom?



This is how I attached the top to my legs.



This is what the back side of my stand looks like.