Clean wiring for 4 pin RGB LED - connectors, etc.

Discussion in 'LED Aquarium Lighting' started by Eletrik, Jan 5, 2013.

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

  1. Eletrik

    Eletrik Plankton

    Joined:
    Jan 5, 2013
    Messages:
    1
    This is my first time posting in the forum, I hope somebody can help me out. I have a lighting project for an aquarium that will use a mix of Cree HP LED's and 4pin RGB LEDs. I am looking for a way to run clean wires to the 4 pin RGB LED's. There will be about 40 LED's total, two 20 LED panels with each panel about 2 ft apart and each LED about 2 inches apart. I am looking for a modular solution that I can plug in to (after it's wired of course) that will allow me to extend the circuit along the array with pluggable components. Let me know if you have any ideas. Essentially looking for wire to wire and wire to LED connectors for 4 pin RGB LED.

    Thanks,
    b
     
    Eletrik, Jan 5, 2013
    Eletrik, Jan 5, 2013
    #1