Wave2K Placement

I have another question: I want to install my Wave2K tonight. I have a 75G tank. Live rock is piled high on both ends of tank with a "swim through" in the middle. Should I place the wave-maker in the center of tank (where it will look awful) or on one end of the tank? In this case, I would move rock so it sits lower in tank. What position would be best for my two little corals and if it is placed on an end, would the "waves" reach the far side of the tank? Thank you! Kas

 

Well OK. Tried to install it tonight and it doesn't fit in my tank anyway. K-

 

buy a bigger tank for the wave maker

 

We could do a DIY on your fuge and make it sit in your sump. Anything is possible.

 

Otty....sump is too small to put the fuge inside. Forgot to mention-after all the trauma the corals went through last night while I was knocking over/moving liverock, the corals you gave me look really good this morning. They perked right up! Now to get that calcium reactor set up. Kas

 

Dont put the fuge inside of the sump, hang it on the back of it. Pull water from the intake area and then dump it back in around the pump chamber.