Join 3reef now to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.
i wouldnt calibrate until you see noticable flucuations after youve have reading for a decent amount of time. just look at your graphs from the past...
what is a zet light?
checks the seals on the tank. im sure this goes without saying.
If anyone uses the VDM with SOLs I need to know if there are any additional cords to buy! thanks
wow, would have been a sight to see. sorry for the loss.
In this situation, deffinatley go with reefbreeders
the SWC 120 will also peform well in 9 inches...generally the weaker the pump, the higher the water level recommendation also it has to do with the...
You get what you pay for and with an mp10 youd probably only need one..
Im looking for a return pump that uses screws that wont generally rust. I have a mag 7 with a year of use on it and the screws are rusting out....
Ill tell you I have used two different RO skimmers and they recommended 6.5 inches of water depth but they both did fine in 9 inches.
Good advice. I had the same thing happen with my Engineer goby. Never again will I put rocks on top of my sand.
Is there another GFO calculator out there besides the one on the BRS website?
BRS mesh top plus my canopy
I bought an Apex lite unit and have AI SOL super blue lights over my 90 gallon tank. My question is.. Do I need and additional wires or anything...
Separate names with a comma.
