Finally started this build, but had a few questions. I really wanted to test the LEDs/drivers out to make sure they worked before I started soldering everything. To do this I put 7 LED's in series onto the LPC-35-700, screwed them into the Heatsink with the included hardware. I also added nylon washers to the screws to prevent any shorts that might occur. I then used electrical tape to wire all of the LEDs together, plugged the driver in and... nothing. Is this a poor way to test these out, any advice on a good way to make sure everything's working before I solder, or do I just have to bite the bullet and assume everything is working? The power cords you send in the kits are 3 wires (pos,neg,groud), but the driver has only AC/L and AC/N wires. What should we be doing with the ground, anything specific? I just taped it up at the moment. I've also verified that I have the LEDs hooked up in the linked picture configuration. http://www.reefledlights.com/wp-content/uploads/2010/06/Led-Lights-Chart-12.jpg As Always, thank you for your help.