New led setup

I am planning on ordering 2 of your 36 q5 light kits for my 120 48x24x24. I am going to getting a larger tank in the future so I want to build 2 2 foot units so I can just build another when I get the new tank. My question is I found these 15 watt multichip LEDs online that I wish to add to the setup. Would I need to order an additional driver to run four of these lights and would your drivers be able to handle a bulb like this.

 

I'd need to see the specs of the LEDs to be able to say for sure, but my guess is they'd need to be run on separate drivers.

 

Ok the 15 watt ones I didn't like. But found these 20k 10watt bulbs
They're comingnfrom hong kong
16-18v
1400 ma
800lm
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?VISuperSize&item=270732298660

This is where I found em. Spec sheet it shows is from a lower model. I've seen someone else set these up so I was hoping another driver would run these four on each lamp.

 

That page won't load for me, but based on the specs you listed you would need to get two additional LPC-60-1050 drivers for 4 of these LEDs (the LPC-60-1050 outputs 1050mA but only has a max rating of 48V, meaning at most you could drive 3 of these LEDs assuming they were 16V each and not 18V).

 

Yeah it was something I liked on another light but the cost of adding these lights , optics drivers and more is going to add like 300 dollars to this build making it as expensive as buying the two maxspects up front