Needing my Apex Coding looked over.

EB8 Outlets:

[Radion]
Fallback ON
Set ON

[VortechMP10]
Fallback ON
Set ON
If FeedA 005 Then ON
If FeedB 020 Then ON
If FeedC 045 Then ON

[Skimmer]
Fallback OFF
Set ON
If Outlet MainPump = OFF Then OFF
Defer 005:00 Then ON
If FeedA 007 Then ON
If FeedB 022 Then ON
If FeedC 047 Then ON

[MainPump]
Fallback OFF
Set ON
If Power Apex Off 001 Then OFF
If FeedA 005 Then ON
If FeedB 020 Then ON
If FeedC 045 Then ON

[ATO]
Fallback OFF
Set OFF
If Outlet MainPump = OFF Then OFF
If Outlet Ato_A1 = ON Then OFF
If Outlet SumpHigh_A2 = ON Then OFF
If Outlet SumpLow_A3 = ON Then ON
If Outlet AtoRes_A4 = ON Then OFF
Defer 02:00 Then ON
If Time 08:00 to 07:25 Then OFF

[Heater]
Fallback OFF
If Temp > 78.5 Then OFF
If Temp < 78.1 Then ON
If Temp < 70.0 Then OFF
If Outlet MainPump = OFF Then OFF

[Extra-A]
Fallback OFF

[Extra-B]
Fallback OFF

Virtual Outlets:

[Ato_A1]
Set OFF
If Switch1 OPEN Then ON

[SumpHigh_A2]
Set OFF
If Switch3 OPEN Then ON

[SumpLow_A3]
Set OFF
If Switch2 CLOSED Then ON

[AtoRes_A4]
Fallback OFF
If Switch4 CLOSED Then ON


Am I missing anything or anything doesn't work together? IF you add something just mark it in bold and red.

Thanks.

 

set your skimmer to fallback OFF, prevent skimmer overflows in the few minutes between power being restored and your controller starting up when water level is high in the sump.

 

Noted. Thanks.

 

Done.

 

Also defer your ato by at least 5-10 minutes. You don't want the pump to kick on unless the switch stays closed, not if it closes for just a second or two.

 

Sorry I added a 0 there its actually 2 minutes.

 

The last line of your ATO, if time 08:00 to 07:25 then OFF, what is this for, it doesn't make sense to me

 

I have it set to turn on Only for 35mins in the morning while I eat my breakfast and can monitor it. It tops off within 5-6mins which tells me I don't have a lot of evap. throughout the day/night before.

So from [8:00am Today] till [7:25am Tomorrow Morning] the ATO will not turn on. So between 7:25am and 8:00am = 35 mins it will top off everything for the day.

 

Doesn't that kinda defeat the purpose of the ATO though? I think you would want it to top off throughout the day to keep the salinity as stable as possible.

 

As I tested my salinity throughout the past few days when running it, the ato doesnt really effect it at all when adding possibly 1cup of FW every morning. And the main purpose for the ATO to me is not to carry buckets and dump it in..every couple of days. lol. If I had a smaller tank then yes I would let it run its course all day but this is fine for me. Maybe down the road I may break it up to two separate times throughout the day..