Join 3reef now to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.
I typically use the same with decent growth also.
Check your magnesium levels... I have seen similar problems with algea when all other parameters look good. Mg should be around 1320
No. Leave it in assuming it is not anything more than the skeletal remains. It will keep your calcium content up for use by the new corals you put in...
Agree with all except that I typically use one size smaller return line than my drain line. For example, a 1 inch drain gets a 3/4 inch return....
Do your research first. If you cannot be 100% sure that the tank is not Tempered then dont drill it unless you are willing to buy a new tank....
I think most people have preferences based on what they use. With the exception of a few hobbyists I would expect most have only used one or two...
Sounds to me like you have to much flow. This could be due to a couple things: 1. Significant waste in your water (but you should be able to turn...
I would look at upgrading only when it is time to replace your lights or when you extra cash just laying around (like that ever happens these days)....
I do my tanks every 1-2 weeks with about 10%. I do periodic water testing and will adjust the frequency as needed. Much is dependent on the load...
way cool!
Ok, your pump size is fine. Might be slightly on the small side but ok for your application. The key is to make sure you can control the amount of...
pump sizing. When selecting pumps you are correct to make sure you look at the GPH at the height you need. The Quiet One 3000 will only give you...
there are two small polyps growing on mine and i wish to frag the coral to remove them i dont know how tho...:cheesy:
i have a large one in my tank. about 3 inches with no problems. He (i refuse to call him Sally) loves a bit of calimari once a week or so. Never...
mag 2,5,7 all appear the same. Anyone know if the cover is different? Danner's web site shows different part numbers but the pump dimesions are the...
the part of the pump with the hose connectors is broken. I was hoping to replace that part. Where the impeller rests is worn out. This should be...
Ok, here is a different challenge. Can anyone tell me the manufacturer of this pump? the sticker is worn off...
I agree on copper tubing as a really bad idea. As far as putting the tubing under ground goes, if need be I could have my son climb under there and...
I am using x10 modules for my light timers and control switches. Not much more money and so far have been very reliable
solar panel is planned for the sump pump once I determine if I can store enough electricity to cover night hours. Also lets be realistic, even if a...
Separate names with a comma.