diy stand plans

Just got a 90gal rr w/ corner overflow. I have available to me a full workshop at work to make my own stand, all i have to supply is the idea. Can you guys point me in the right direction. Got any ideas, plans, examples.

Thanx in advance.

 

All you need is some 2x4s, a chop saw, 2-1/2" or 3" wood screws, and a drill/screwgun.
Build two rectangles to match the dimensions of the bottom of your tank.
Then put on 4 legs, and maybe some extra 2x4s run diagonal on the sides and between the top and bottom frames for support.

 

what if i were looking for something a little bit more decorative..

 

you can add decorative stuff after you get the basic frame build as above

 

I could build you one if you were local, but it would cost ya.
Or you could buy one pre-made from Oceanic. Or you could have a local custom cabinet maker build you a stand.

 

My only suggestion is to make sure you factor in all equipment that will end up inside the stand. Fuge/sump, protein skimmer, lighting etc etc etc... Also make sure that you will if need be; be able to remove the fuge/sump from the front or side.

 

i built this one for someone else. but you could do something like this with the framing underneath.

 

FishandTips.com: tropical fish and plants info

this isnt a bad place to get a start..

 

FishandTips.com: Fish database

 

The link above has you put all your info in and give you a shopping list and directions...