3reef Forums - View Single Post

icedgxe · 01-28-2008, 03:30 PM

Ok...here is my problem. I had a small amount of cyno. in a couple of dead spots (which have now had more flow added too) a while back. About 3 weeks or so. I decided to try ultralife red slime remover (which I will never use again if I can help it) to help rid the problem while I fixed flow issue. My problem is this. I have not been able to turn my skimmer on since. The skimmer fills up right away and is causing a ton of fizz like microbubbles. It has been three weeks and I have done 4 water changes trying to be able to get my skimmer up and running normally again. I am running a phosban reactor with seachem gel in it. The skimmer is a euro reef rs135. I am pulling my hair out trying to get the skimmer up and running normally again.

Any suggestions will be greatly appreciated.

01-28-2008, 03:30 PM	#1 (permalink)
icedgxe Spanish Shawl Nudibranch Join Date: Nov 2007 Posts: 75 Karma: 137	Extremely frustrated! Ok...here is my problem. I had a small amount of cyno. in a couple of dead spots (which have now had more flow added too) a while back. About 3 weeks or so. I decided to try ultralife red slime remover (which I will never use again if I can help it) to help rid the problem while I fixed flow issue. My problem is this. I have not been able to turn my skimmer on since. The skimmer fills up right away and is causing a ton of fizz like microbubbles. It has been three weeks and I have done 4 water changes trying to be able to get my skimmer up and running normally again. I am running a phosban reactor with seachem gel in it. The skimmer is a euro reef rs135. I am pulling my hair out trying to get the skimmer up and running normally again. Any suggestions will be greatly appreciated.